Best answer: How long should a windshield wiper motor last?

Windshield wiper motors are designed to last up to 1.5 million wipes, so they should be able to keep the rain, snow, and road grime off your windshield for years and years. But sometimes, these motors just wear out.

How do I know if my windshield wiper motor is bad?

Symptoms of a Bad Windshield Wiper Motor

  1. Wiper Blades Start Moving Slower.
  2. Wiper Blades Only Move at One Speed.
  3. Wiper Blades Stop Moving Completely.
  4. Wiper Blades Refuse to Park in the Correct Position.
  5. Humming Noises.

How long does wiper motor last?

The wiper motor on a car is supposed to last a lifetime. Typically, this will not be the case due to the conditions that this part of a car is exposed to. The heat and moisture that a wiper motor is exposed to on a daily basis will eventually lead to you having to get it replaced.

How much does it cost to replace a windshield wiper motor?

The average cost for windshield wiper motor replacement is between $300 and $354. Labor costs are estimated between $79 and $99 while parts are priced between $222 and $254. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

THIS IS IMPORTANT:  Can you BulletProof a Northstar engine?

What causes windshield wiper motor failure?

Your Windshield Wipers Are Moving Very Slowly



If your windshield wipers are moving slower than normal, then you may have dirt or other debris stuck somewhere. This can cause the windshield wiper motor to move slowly, and even work harder than it has to. All this work will eventually cause the motor to give out.

How do you test a wiper motor?

Use the fuse pattern shown on the cover and locate the wiper motor fuse. Test the fuse using your twelve volt test light. Clip the ground lead to a solid ground source and touch the positive lead to each side of the fuse. If the test light lights up on both terminals, the fuse is good.

How powerful is a wiper motor?

At any rate an average wiper draws 5 amps, rising to 10 to 12 amps under heavy/stall load. Supposing the motor efficiency is 60% then the total power maxes out around 4 x 10 x 12 watts = 480 watts input and 0.6 x 480 watts output power .

How do you know if your windshield wiper fuse is blown?

The blown fuse will cut the power, shutting down the wiper system. Solution: Check your owner’s manual for the location of your fuses, and to identify which fuse protects the wiper motor. Pull out the fuse and inspect it — if it’s blown, you should be able to see a broken wire inside it, or char marks.

Is a windshield wiper motor covered under warranty?

Typically, a warranty won’t cover wear and tear items. These include things like tyres, windscreen wipers, brakes or clutches. … All major vehicle systems—If you purchase a bumper-to-bumper extended warranty, most parts of your vehicle are covered, including air conditioning.

THIS IS IMPORTANT:  Which electric car gets the best mileage?

How much does it cost to replace a windshield wiper fuse?

Buy a replacement fuse of the correct amperage, then swap out the old one. If your wipers come back to life, a blown fuse was the problem. Cost of parts: About $10 for an assortment of 100 fuses. Cost of professional labor: $20 to $50.

How do I unfreeze my windshield wiper motor?

Try pouring some hot water on the lines and the spray nozzle(s), then try using your windshield washer. Perhaps some water got into the lines and they are frozen. This happens alot with my car in the winter time and the hot water resolves the problem everytime.

What happens when a wiper relay goes bad?

When the relay is faulty, the windshield wipers will only work at the same speed that the last relay signal was sent. … If you make a change in the settings and the wipers don’t react, it’s most likely due to a malfunction in the intermittent wiper relay.

How do you remove a windshield wiper motor?

How to Replace a Windshield Wiper Motor?

  1. Remove the wiper blades using a windshield wiper removal tool.
  2. Locate the windshield wiper motor. …
  3. Remove clips/ screws that are holding the cowl in place.
  4. Unplug and unbolt the old motor.
  5. Remove the old motor from the vehicle.
Encyclopedia auto repair