Why would blower motor stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Blower motors generally don’t fail out of the clear blue.

What causes a blower motor to stop working?

The most common reason why your blower motor won’t work on any speed is that you have a bad or blown a fuse. … You want to make sure to check the blower motor fuse and also the HVAC controller fuse because either one of these being blown can cause the blower motor to stop working.

How do I know if my blower motor fuse is bad?

Symptoms of a bad heater blower motor resistor

  1. Fan does not work at all, so no air comes out of the vents.
  2. Fan only works on some speeds and not others.
  3. Fan only works on the highest speed.
  4. Fan runs all the time and can’t be controlled with the fan switch.
  5. You see smoke coming out of the vents.

What happens when blower motor relay goes bad?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

THIS IS IMPORTANT:  Question: Is a 1 0 engine bad?

Is there a fuse for blower motor?

The blower motor is powered by a fuse-like device called a relay. If your heater or air conditioner does not blow air through the vents, this could indicate that the blower motor fuse has probably blown. While replacement is easy, the exact location of your blower motor fuse may vary from vehicle to vehicle.

How much does it cost to replace a blower motor?

Cost to Replace Central or Forced Air Blower Motor



Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.

How do I know if my blower motor has power?

Check for power at the motor itself. Using a test light or a multimeter set on volts, unplug the blower motor. Keeping the black lead on a good ground, usually a bolt on the engine block, and the blower switch turned on, use the red lead to probe the plug that usually attaches to the blower motor.

How do you test a bad blower motor relay?

Connect a test light or multimeter to the ground (black lead). Turn the ignition key to the on position (engine off), and remove the relay. Using the probe, test all terminal sockets in the relay connector. Two of the four should have power.

How do you diagnose a bad blower motor resistor?

What are the symptoms of a bad blower motor resistor?

  1. No Air. …
  2. High speeds only. …
  3. Low speed only. …
  4. Fan won’t turn off. …
  5. Blower motor works on some settings but not others. …
  6. Smoking vents. …
  7. Burning smell.
THIS IS IMPORTANT:  Can you just add transmission fluid?
Encyclopedia auto repair